Insignia™ – Apple Watch Magnetic Charging Cable and Silicone Cable Wrap (4′) – White

Refill your watch’s battery with this Insignia charging cable for Apple Watch. The 4-foot length offers flexible placement, and the USB-A adapter provides compatibility with a variety of wall chargers and power banks. The included cable management bumper makes it easy to store this Insignia charging cable without tangles or knots.
Compatible with Apple Watch
Including all Apple Watch Series 7, Apple Watch SE, Series 6, Series 5, Series 4, Series 3, Series 2, and Series 1 models. For use with your existing device.
Four-pin USB Type-A connector
Provides easy charging and synchronizing.
4′ length
Offers flexible placement options.
Cable management bumper
Ensures proper cable custody.
The circular charging module is slightly larger than standard size and may not fit in all charging stands designed for Apple Watch.
Apple Watch is a trademark of Apple Inc.
This device complies with Part 18 of the FCC Rules
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Increase the separation between the equipment and the receiver.
-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.